Flower Bead Clear Glass Pitcher 20.5 cm Tall 1220 g Heat Resistant Beverage Serving Jug

Flower Bead Clear Glass Pitcher 20.5 cm Tall 1220 g Heat Resistant Beverage Serving Jug is a glass pitcher built around a tapered jug with wide pouring mouth and a solid loop handle in clear with yellow, green and white flower bead accents, with scattered flower shaped glass beads applied to the body. It is produced in our glass workshop for buyers who need a repeatable decorative programme rather than a one off sample, and the piece shown here carries the small flower beads scattered across a clear jug, a quiet decorative note for table service.

The beads are fused during annealing, so there is no adhesive line where detergent can collect, which keeps the jug hygienic in daily hotel use. Every unit is annealed in a controlled lehr so that wall stress stays within our breakage specification, and dimensions are checked against the measurement sheet printed on the photography. The result is a glass that looks individual on the shelf but behaves predictably in a container load.

• Heat Resistant Body: The thick wall is annealed for thermal shock resistance, so warm water and iced water can share the same jug.
• Flower Bead Decoration: Yellow, green and white flower beads are applied at intervals, breaking up the clear surface without hiding the contents.
• Wide Pouring Mouth: The 11.8 by 10.5 cm mouth leaves room for ice cubes and citrus slices and pours without a separate spout.
• Solid Loop Handle: The handle is drawn from the same gather and shaped for a full hand grip even when the jug is filled.
• 1220 g Balanced Build: A heavy base with a modest 20.5 cm height keeps a full jug stable on a serving tray.
• Practical Capacity: The body holds enough for four to six servings, matching restaurant table service routines.

This glass pitcher is aimed at hotel breakfast service, cafe water stations, garden party tables, gift and homeware retail. Buyers typically place it in a range that needs one recognisable decorative accent without moving to a full bespoke mould, and because the body is a standard production shape the tooling cost is already absorbed into the piece price.

In service the glass is expected to move between back of house washing and front of house display several times a day. The surface withstands standard commercial detergents, and the rim geometry has been kept simple so that stacking and racking do not put point loads on the lip. For retail programmes the same item can be boxed as a single unit or combined with the matching pieces in our range to build a story around colour and pattern.

Sampling buyers usually test three things: whether the decoration survives twenty dishwasher cycles, whether the base sits flat on a granite or marble surface, and whether case pack dimensions match their pallet plan. All three can be confirmed with a stock sample before any production deposit is placed.

Each piece is packed in a moulded pulp or corrugated divider inside a five layer export carton, with a printed sleeve available for retail programmes. Case pack quantities are set so that a full pallet loads without void fill, which keeps freight cost per unit down for mixed container orders.

Production is inspected at three points: incoming glass quality, decoration placement, and final packing. AQL inspection follows the usual 2.5 major and 4.0 minor plan unless a buyer specifies otherwise, and we keep a retained sample from each run so that repeat orders can be matched for colour and pattern density.

• Flower Bead Glass Pitcher
• Heat Resistant Serving Jug
• Decorated Clear Pitcher

Hand washing with a soft sponge is recommended where a decorative surface is present, and dishwasher use is acceptable on a normal cycle at moderate temperature. Avoid sudden temperature change such as pouring boiling liquid into a chilled glass, since thermal shock remains the most common cause of breakage in any annealed glassware. Stored correctly, the piece is designed for years of daily use.