Bubble Inclusion Stemmed Wine Glass 22.5 cm Tall 200 g Clear Bowl Stemware

Bubble Inclusion Stemmed Wine Glass 22.5 cm Tall 200 g Clear Bowl Stemware is a stemmed wine glass built around a tapered bowl on a pulled stem over a round foot in clear with fine suspended bubbles, with seeded bubbles scattered evenly through the bowl wall. It is produced in our glass workshop for buyers who need a repeatable decorative programme rather than a one off sample, and the piece shown here carries the seeded bubbles suspended in clear glass, which gives movement to the wine without any surface decoration.

Seeded glass is often specified for bars because the bubbles hide fine scuffs that would show immediately on a plain bowl. Every unit is annealed in a controlled lehr so that wall stress stays within our breakage specification, and dimensions are checked against the measurement sheet printed on the photography. The result is a glass that looks individual on the shelf but behaves predictably in a container load.

• Seeded Bubbles: Fine bubbles are trapped inside the wall, so the texture cannot wash off and the outside stays smooth.
• Clear Ground: No tint or pattern, which means the wine colour is judged accurately in service.
• 22.5 cm Height: A mid height bowl that works for both still wine and sparkling service.
• 200 g Weight: Solid enough for a busy bar without feeling heavy at the pass.
• 8 cm Foot: A wide foot under a 200 g bowl keeps the centre of gravity low.
• Even Seed Distribution: Bubbles are distributed through the gather rather than applied, so density stays consistent between pieces.

This stemmed wine glass is aimed at restaurant and hotel wine service, cocktail bars and retail gift sets. Buyers typically place it in a range that needs one recognisable decorative accent without moving to a full bespoke mould, and because the body is a standard production shape the tooling cost is already absorbed into the piece price.

In service the glass is expected to move between back of house washing and front of house display several times a day. The surface withstands standard commercial detergents, and the rim geometry has been kept simple so that stacking and racking do not put point loads on the lip. For retail programmes the same item can be boxed as a single unit or combined with the matching pieces in our range to build a story around colour and pattern.

Sampling buyers usually test three things: whether the decoration survives twenty dishwasher cycles, whether the base sits flat on a granite or marble surface, and whether case pack dimensions match their pallet plan. All three can be confirmed with a stock sample before any production deposit is placed.

Each piece is packed in a moulded pulp or corrugated divider inside a five layer export carton, with a printed sleeve available for retail programmes. Case pack quantities are set so that a full pallet loads without void fill, which keeps freight cost per unit down for mixed container orders.

Production is inspected at three points: incoming glass quality, decoration placement, and final packing. AQL inspection follows the usual 2.5 major and 4.0 minor plan unless a buyer specifies otherwise, and we keep a retained sample from each run so that repeat orders can be matched for colour and pattern density.

• Bubble Inclusion Stemware
• Seeded Glass Wine Glass
• Clear Bubble Bowl

Hand washing with a soft sponge is recommended where a decorative surface is present, and dishwasher use is acceptable on a normal cycle at moderate temperature. Avoid sudden temperature change such as pouring boiling liquid into a chilled glass, since thermal shock remains the most common cause of breakage in any annealed glassware. Stored correctly, the piece is designed for years of daily use.