Purple Red Bubble Glass Tumbler 8.7 cm Rim 10 cm Tall 330 g Hand Blown Look for Home Bar

Purple Red Bubble Glass Tumbler 8.7 cm Rim 10 cm Tall 330 g Hand Blown Look for Home Bar is a glass tumbler built around a slightly tapered body, wider rim and narrower base in purple red translucent, with dense internal bubble decoration. It is produced in our glass workshop for buyers who need a repeatable decorative programme rather than a one off sample, and the piece shown here carries the deep purple red tone that reads elegant on open shelving and bar carts.

Because the bubble layer is formed inside the wall rather than printed on the surface, the pattern cannot peel, fade or wash off after commercial dishwashing. Every unit is annealed in a controlled lehr so that wall stress stays within our breakage specification, and dimensions are checked against the measurement sheet printed on the photography. The result is a glass that looks individual on the shelf but behaves predictably in a container load.

• Dense Bubble Texture: Thousands of tiny air bubbles are trapped inside the glass wall, giving each tumbler a hand blown character that stays identical from piece to piece.
• Purple Red Colour: The translucent purple red tone filters light softly, so the glass reads rich on the shelf while drinks remain clearly visible.
• Tapered Silhouette: A 8.7 cm rim narrows to a 6 cm base, which keeps the centre of gravity low and makes the tumbler comfortable for both water and mixed drinks.
• 330 g Solid Weight: At 330 g per piece the glass feels substantial in the hand without becoming tiring during long service shifts.
• Polished Rim: The rim is fire polished and rounded, so lips meet a smooth edge and dishwasher cycles will not chip the lip line.
• Stable Thick Base: A reinforced base with a slight punt protects tables and reduces the chance of thermal shock cracks.

This glass tumbler is aimed at hotel minibars, cocktail bars, restaurant water service, home entertaining and gift sets. Buyers typically place it in a range that needs one recognisable decorative accent without moving to a full bespoke mould, and because the body is a standard production shape the tooling cost is already absorbed into the piece price.

In service the glass is expected to move between back of house washing and front of house display several times a day. The surface withstands standard commercial detergents, and the rim geometry has been kept simple so that stacking and racking do not put point loads on the lip. For retail programmes the same item can be boxed as a single unit or combined with the matching pieces in our range to build a story around colour and pattern.

Sampling buyers usually test three things: whether the decoration survives twenty dishwasher cycles, whether the base sits flat on a granite or marble surface, and whether case pack dimensions match their pallet plan. All three can be confirmed with a stock sample before any production deposit is placed.

Each piece is packed in a moulded pulp or corrugated divider inside a five layer export carton, with a printed sleeve available for retail programmes. Case pack quantities are set so that a full pallet loads without void fill, which keeps freight cost per unit down for mixed container orders.

Production is inspected at three points: incoming glass quality, decoration placement, and final packing. AQL inspection follows the usual 2.5 major and 4.0 minor plan unless a buyer specifies otherwise, and we keep a retained sample from each run so that repeat orders can be matched for colour and pattern density.

• Dense Bubble Glass Tumbler
• Purple Red Drinking Cup
• Hand Blown Bar Tumbler

Hand washing with a soft sponge is recommended where a decorative surface is present, and dishwasher use is acceptable on a normal cycle at moderate temperature. Avoid sudden temperature change such as pouring boiling liquid into a chilled glass, since thermal shock remains the most common cause of breakage in any annealed glassware. Stored correctly, the piece is designed for years of daily use.